How to get the IoT token from a PQube 3?

An IoT token is required to pair a PQube 3 Power Analyzer to a measurement point in QubeScan fleet management software.

Note:
Access to Internet is required and port 8883
must be enabled/opened on your router.


To get the IoT token directly from your PQube 3

  1. Use the PQube 3 display screen, and select [System] [Advanced], then press [IoT token].

  2. Allow a few seconds for the IOT token to appear, then note of the 6-digit code. This is the code you will need to pair the PQube 3 with the measurement point in QubeScan.

To get the IoT token remotely

  1. Connect to the PQube 3 web pages and type in the PQube3 IP address.

  2. Click [Command] on the left navigation bar, then click the [Request IoT token] button in the Actions & Commands section.

  3. Allow a few seconds for the message containing the IoT token to appear, then note of the 6-digit code. This is the code you will need to pair the PQube 3 with the measurement point in QubeScan.